Cisco Catalyst 9800-80 - Environmental Monitoring Details

Step 5 Enter an enable secret password. This password is encrypted (for more security) and cannot be seen when viewing the
configuration.
The enable secret is a password used to protect access to privileged EXEC and configuration modes.
This password, after entered, becomes encrypted in the configuration.
Enter enable secret: $9$.3E/eKj7KQhfik$6HKawMLMqDjcbKpVUzJ0/I3PwyBnHbIq17OitMW4T.s
Step 6 Enter an enable password that is different from the enable secret password. This password is not encrypted (and is less
secure) and can be seen when viewing the configuration.
The enable password is used when you do not specify an
enable secret password, with some older software versions, and some boot images.
Enter enable password: cisco123
Step 7 Enter the virtual terminal password, which prevents unauthenticated access to the controller through ports other than
the console port:
The virtual terminal password is used to protect access to the router over a network interface.
Enter virtual terminal password: cisco123
Step 8 Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [no]: yes
Community string [public]:
A summary of the available interfaces is displayed. The interface summary includes interface numbering, which is
dependent on the controller, installed modules, and interface cards.
Current interface summary
Interface IP-Address OK? Method Status Protocol
Te0/0/0 unassigned YES unset down down
Te0/0/1 unassigned YES unset down down
Te0/0/2 unassigned YES unset down down
Te0/0/3 unassigned YES unset down down
GigabitEthernet0 unassigned YES unset up up
Vlan1 unassigned YES unset down down
Enter interface name used to connect to the
management network from the above interface summary: GigabitEthernet0
Step 9 Respond to the following prompts as appropriate for your network:
Configuring interface GigabitEthernet0:
Configure IP on this interface? [yes]: yes
IP address for this interface: 10.104.33.77
Subnet mask for this interface [255.0.0.0] : 255.255.255.0
Class A network is 10.0.0.0, 24 subnet bits; mask is /24
The following configuration command script is created:
hostname myWLC
enable secret 9 $9$.3E/eKj7KQhfik$6HKawMLMqDjcbKpVUzJ0/I3PwyBnHbIq17OitMW4T.s
enable password cisco123
line vty 0 15
password cisco
username admin privilege 15 password cisco
snmp-server community public
!
!
interface TenGigabitEthernet0/0/0
!
Cisco Catalyst 9800-80 Wireless Controller Hardware Installation Guide
58
Power Up and Initial Configuration
Using the Cisco Setup Command Facility