Cisco Catalyst 9800-80 - Page 81

Base Ethernet MAC Address : 00:A3:8E:23:9B:C0
Installation mode is BUNDLE
Configuration register is 0x2102
WLC#
show inventory Command
The show inventory command displays an extended report that includes the product inventory listing of all
the Cisco products installed in the networking device.
The following is sample output from the show inventory command:
NAME: "Chassis 2", DESCR: "Cisco C9800-80-K9 Chassis"
PID: C9800-80-K9 , VID: V01 , SN: FXS2209Q2EN
NAME: "Chassis 2 Power Supply Module 0", DESCR: "Cisco 750 Watt AC power supply"
PID: C9800-AC-750W , VID: V01 , SN: POG22107X2X
NAME: "Chassis 2 Fan Tray", DESCR: "Cisco C9800-80-K9 Fan Tray"
PID: C9800-80-K9-FAN , VID: , SN:
NAME: "module 0", DESCR: "Cisco C9800-80-K9 Modular Interface Processor"
PID: C9800-80-K9 , VID: , SN:
NAME: "SPA subslot 0/0", DESCR: "6-port 10G/2-port 1G multirate Ethernet Port Adapter"
PID: BUILT-IN-6X10G/2X1G, VID: N/A , SN: JAE12345678
NAME: "subslot 0/0 transceiver 0", DESCR: "10GE SR"
PID: SFP-10G-SR , VID: V03 , SN: AVD2106A6PR
NAME: "module R0", DESCR: "Cisco C9800-80-K9 Route Processor"
PID: C9800-80-K9 , VID: V01 , SN: FXS2209Q2EN
NAME: "module F0", DESCR: "Cisco C9800-80-K9 Embedded Services Processor"
PID: C9800-80-K9 , VID: , SN:
NAME: "Crypto Asic F0/0", DESCR: "Asic 0 of module F0"
PID: ASR1002HX-IPSECHW , VID: V01 , SN:
WLC#
show platform Command
The show platform command displays platform information.
The following is sample output from the show platform command:
WLC# show platform
Chassis type: C9800-80-K9
Slot Type State Insert time (ago)
------ ------------------- --------------------- -----------------
0 C9800-80-K9 ok 00:06:38
0/0 BUILT-IN-4X10G/1G ok 00:05:16
R0 C9800-80-K9 ok, active 00:06:38
F0 C9800-80-K9 ok, active 00:06:38
P0 C9800-AC-750W-R ok 00:06:10
P1 Unknown ps, fail never
P2 C9800-80-K9-FAN ok 00:06:11
Cisco Catalyst 9800-80 Wireless Controller Hardware Installation Guide
71
Power Up and Initial Configuration
show inventory Command