Step 19 (Optional) Configure AAA servers:
You can configure a maximum of 6 servers during Day 0 configuration.
Note
Configure AAA servers? [yes]:
Enter the AAA server address: 9.11.112.46
Enter the AAA key: ***
Do you want to add more AAA servers? [yes]:
Enter the AAA server address: 9.11.112.47
Enter the AAA key: ***
Do you want to add more AAA servers? [yes]: no
The AAA servers are required for WPA2 Enterprise. You need to configure AAA only in one place. If
you follow Step 21, WPA2 Enterprise will not ask for AAA servers in Step 22.
Note
Step 20 (Optional) Configure the wireless network settings to configure WLAN information for an AP and client join:
Configure Wireless network settings? [yes]:
Step 21 (Optional) Configure an SSID for client join:
Enter the network name or service set identifier (SSID):
Choose the network type
1. Employee
2. Guest
If you choose Employee as the network type, the following options are displayed:
Choose the security type
1. WPA Personal
2. WPA Enterprise
Enter your selection [2]:
If you choose WPA2 Personal, you will need to enter a pre-shared key (ASCII).
Enter the pre-shared key (ASCII):
If you choose WPA2 Enterprise, you will be able to add multiple AAA servers.
Enter the AAA server address:
Enter the AAA key:
Enter more AAA server details? [yes]
If you choose Guest, you get to view the following options:
Please choose the security type:
1. Webauth
2. Authbypass
3. Consent
4. Webconsent
Enter the security type:
Step 22 (Optional) Configure a virtual IP address. The recommended virtual IP address is 192.0.2.1.
Configure virtual IP? [yes]:
Enter the virtual IP [192.0.6.1]:
Step 23 (Optional) Configure an RF network name.
Cisco Catalyst CW9800H1 and CW9800H2 Wireless Controllers Hardware Installation Guide
64
Power Up and Initial Configuration
Using the Cisco IOS-XE CLI - Cisco Setup Command Facility
To Next Page
Loading...
