Cisco Catalyst CW9800H1 - Page 75

Configure RF-Network Name? [yes]:
Enter the RF-Network Name: ciscorf
Step 24 (Optional) Configure high availability.
Irrespective of the deployment mode; Active or Standby, the default HA pairing type is RMI
For information on HA pairing types, see Part: High Availability (High Availability > Information
About Redundancy Management Interface) in Cisco Catalyst CW9800M Wireless Controller Software
Configuration Guide.
Note
If you have not configured a default route earlier, you need to enter the gateway IP of the last resort.
Note
If you choose the deployment mode as Standby, you need to specify the VLAN ID for completing the pairing:
Enter the RMI IP for local chassis: 9.11.112.51
Enter the RMI IP for remote chassis: 9.11.112.50
Enter the wireless management VLAN: 112
Completing the Configuration
When using the Cisco setup command facility, and after you have provided all the information requested by
the facility as described in Using the Cisco setupCommand Facility section, the final configuration appears.
To complete your controller configuration, follow these steps.
Step 1 The facility prompts you to save the configuration.
• If you answer no, the configuration information you entered is not saved, and you return to the controller enable
prompt (WLC#). Enter setup to return to the System Configuration dialog box.
• If you answer yes, the configuration is saved, and you are returned to the user EXEC prompt (WLC>).
Use this configuration? {yes/no} : yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
%LINK-3-UPDOWN: Interface GigabitEthernet0/1/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1/0, changed state to up
<Additional messages omitted.>
Step 2 When messages stop appearing on your screen, press Return to get the WLC> prompt.
Step 3 The WLC> prompt indicates that you are now at the command-line interface (CLI).
You have just completed an initial controller configuration. Note that this is not a complete configuration. At this point,
you have two choices:
• Run the setup command facility again, and create another configuration:
Device> enable
Password: password
Device# setup
Cisco Catalyst CW9800H1 and CW9800H2 Wireless Controllers Hardware Installation Guide
65
Power Up and Initial Configuration
Completing the Configuration