Cisco Catalyst CW9800H1 - Page 76

• Modify the existing configuration or configure additional features by using the CLI:
Device> enable
Password: password
Device# configure terminal
Device(config)#
Using the Cisco IOS-XE CLI—Manual Configuration
This section shows you how to access the CLI to perform the initial configuration on the controller
If the system configuration message does not appear, it means a default configuration file was installed on
the controller prior to shipping.
Follow these steps to configure the controller.
Step 1 Enter no when the following system message appears on the controller.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2 Press Return and continue with the manual configuration:
Several log messages are displayed.
Step 3 Press Return to bring up the WLC> prompt
Step 4 Type enable to enter privileged EXEC mode.
Device> enable
Device#
Configuring the Controller Hostname
The provides a simplified first time out-of-box installation and configuration interface for all series of wireless
controllers.
To learn more about the Day 0 Express setup on the , please refer https://www.cisco.com/c/en/us/td/docs/
wireless/controller/technotes/8-8/b_c9800_wireless_controller_series_web_dg.html
Note
If you prefer to configure the device manually, you need to configure the following to terminate the Day0
Wizard:
• Wireless management interface
• AP country code must be set
Note
Cisco Catalyst CW9800H1 and CW9800H2 Wireless Controllers Hardware Installation Guide
66
Power Up and Initial Configuration
Using the Cisco IOS-XE CLI—Manual Configuration