EasyManuals Logo

Cisco CDE 220 Series User Manual

Cisco CDE 220 Series
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #136 background imageLoading...
Page #136 background image
4-4
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
Chapter 4 Installing the VDS Internet Streamer Software and Initially Configuring a CDE
Launching a New CDE for the First Time
Figure 4-2 Configuring the CIMC IP
Note When configuring CIMC, pay close attention to the 'NIC Mode' and 'NIC Redundancy' settings. If these
are set incorrectly, CIMC configures itself to use network ports other than the dedicated CIMC port
causing issues.
We recommend that you set the NIC mode to Dedicated and the NIC redundancy to None.
Step 4 Ping the IP address associated with the CIMC port.
Step 5 After verifying the CIMC interface is reachable, verify that the CIMC Web Interface is available by
pointing your Web-browser to its IP address:
https://<CIMC IP>
Step 6 Enter admin as the username and the default password as password.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CDE 220 Series and is the answer not in the manual?

Cisco CDE 220 Series Specifications

General IconGeneral
BrandCisco
ModelCDE 220 Series
CategoryServer
LanguageEnglish

Related product manuals