Cisco CDE 220 Series User Manual

4-29
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
Chapter 4 Installing the VDS Internet Streamer Software and Initially Configuring a CDE
Re manufacturing a CDE
9. Force manufacturing flash
Choice [0]:
Enter full URL of .bin image to install.
ftp://[user:pass@]ip_addr/path/to/file
http://[user:pass@]ip_addr/path/to/file
file:/local/path/to/to/file
URL for .bin image [file:/cdrom/images/CDS23.bin]:
Continue? This will wipe out all disks! [n]: y
Erasing disks
Disk drive not supported. (type 5 host 3 chan 0 id 8 lun 0)
Unsupported disk hardware.
diskman: fread flash disk config rc=0
Creating SYSTEM and SYSFS volumes on [disk00]
Creating SYSTEM and SYSFS volumes on [disk01]
New drive [disk02] detected: allocating to CDNFS volume.
Reading and installing image, it may take a few minutes, please wait...
remote size / mtime: 253105823 / 1221548342
cookie_check: Skip supported platform check for Model:CDE205
Reclaiming unused flash safe state sectors ... Done.
######################################################################################
######################################################################################
#####################################################################
253105823 bytes transferred in 81.5 seconds (2.96 MBps)
Installing phase3 bootloader...
Installing system image to flash: done.
cat: /etc/PERSONALITY: No such file or directory
Installing application components...[ap] [di] [jr] [li] [me] [pe] [to] [un]
Running post-install hooks...
Syncing filesystems...
/ruby/bin/install-to-sw: DONE.
Successfully installed product image.
MODEL: CDE205
FLASH: found, directory validated
COOKIE: valid
IMAGE: 2.3.1.2
FLASHDEV: /dev/hda
Installer Main Menu:
1. Configure Network
2. Manufacture flash
3. Install flash cookie
4. Install flash image from network
5. Install flash image from cdrom
6. Install flash image from disk
7. Wipe out disks and install .bin image
8. Exit (and reboot)
9. Force manufacturing flash
Choice [0]:
Step 6 Eject the CD from the CD-ROM drive, disconnect the CD-ROM drive from the CDE, and choose Option
8 to exit and reboot. Press Y and Enter to confirm the reboot request.
The system boots from the IDE compact flash drive with the data installed from the CD. All prior data
is removed and the original system remains unaffected.

Cisco CDE 220 Series Specifications

General

Brand	Cisco
Model	CDE 220 Series
Category	Server
Language	English