CHAPTER
6-1
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
6
Installing the VQE and Initially Configuring a
CDE
This chapter describes the initial installation of the Cisco VQE software application suite, and the initial
configuration of a CDE.
• Launching a New CDE250 for the First Time, page 6-1
• Re-manufacturing a CDE, page 6-2
If you receive a new CDE250 go to the “Launching a New CDE250 for the First Time” section on
page 6-1.
If you receive a new CDE280 go to the “Launching a New CDE280 for the First Time” section on
page 6-1section on page.
If you need to re-manufacture a CDE for any reason, see the “Re-manufacturing a CDE” section on
page 6-2.
Launching a New CDE250 for the First Time
To launch a CDE250 for the first time, see “VQE Software Installation Types” section in the Release Notes
for Cisco CDA Visual Quality Experience Application Release 3.11.
Launching a New CDE280 for the First Time
For CDE280, you can use the CIMC to manage your device. To use the CIMC, you have to configure it.
This section describes the following tasks:
• Configure the CIMC IP, page 6-1
• Configure Remote Presence, page 6-2
• Connect to the Console, page 6-2
• Configure VQE Software, page 6-2
• Configuring SNMP, page 6-2
Configure the CIMC IP
To configure CIMC IP, see “Configure the CIMC IP” section on page 4-3.
To Next Page
Loading...
