1-36
Cisco IOS XR Troubleshooting Guide for the Cisco CRS-1 Router
OL-21483-02
Chapter 1 General Troubleshooting
Validating and Troubleshooting Cisco IOS XR Software Configuration
!
interface Loopback0
ipv4 address 10.1.1.1 255.255.255.255
!
interface MgmtEth0/RP0/CPU0/0
description Connected to Lab LAN
ipv4 address 172.29.52.70 255.255.255.0
!
interface MgmtEth0/RP1/CPU0/0
description Connected to Lab LAN
ipv4 address 172.29.52.71 255.255.255.0
!
interface GigabitEthernet0/1/5/0
description Connected to P2_CRS-8 GE 0/1/5/0
ipv4 address 10.12.16.1 255.255.255.0
!
interface GigabitEthernet0/1/5/1
description Connected to P4_C12810 GE 5/2
ipv4 address 10.14.8.1 255.255.255.0
!
interface GigabitEthernet0/1/5/2
description Connected to PE6_C12406 GE 0/4/0/1
ipv4 address 10.16.4.1 255.255.255.0
!
interface GigabitEthernet0/1/5/3
shutdown
.
.
.
interface POS0/1/4/1
description Connected to P2_CRS-8 POS 0/1/4/1
bundle id 24 mode active
!
interface POS0/1/4/2
description Connected to P2_CRS-8 POS 0/1/4/2
ipv4 address 10.12.32.1 255.255.255.0
!
interface POS0/1/4/3
description Connected to P2_CRS-8 POS 0/1/4/3
ipv4 address 10.12.36.1 255.255.255.0
.
.
.
controller SONET0/6/4/6
clock source internal
!
The output displays all the configured interfaces on the node.
Use the show sysdb trace commands to display the contents of the SysDB after a configuration change.
The trace information includes a history of any changes to the running configuration. You can specify
either a local node or the shared plane.
The following example output shows the contents of the SysDB local plane:
RP/0/RP0/CPU0:router# show sysdb trace verification location 0/5/cpu0 reverse
Timestamp jid tid reg handle connid action
path
656 wrapping entries (4096 possible, 3440 filtered, 6460 total)
Aug 29 06:14:38.443 116 1 20 38446 apply reply
'--'
Aug 29 06:14:38.442 116 1 20 1139 Apply/abort called
'cfg/if/act/POS0_5_0_0/keepalive'
To Next Page
Loading...
Need help?
General
