EasyManuals Logo

Cisco CRS-1 - Carrier Routing System Router Troubleshooting Guide

Cisco CRS-1 - Carrier Routing System Router
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
1-50
Cisco IOS XR Troubleshooting Guide for the Cisco CRS-1 Router
OL-21483-02
Chapter 1 General Troubleshooting
ASIC Errors
–
Address—Address that encountered the SBE
–
Data—Actual error data
• PARITY Errors—Parity error in all applicable memory
Reported to PM as Major.
• Cyclic redundancy check (CRC) Errors—CRC errors in EIO other links.
Not reported for each occurrence. When the threshold is reached it is reported as Major to the PM.
• GENERIC Errors—Errors that do not fall under any of the other classifications.
Threshold and alarm reporting is done.
• RESET Errors—Logged for each reset instance of the ASIC.
Reported to PM when threshold is exceeded.
Error data:
–
Interrupt status—Interrupt status bits due to ASIC reset.
–
Halt status—Halt status bits.
–
Reset node key—Key for the error node that causes the reset.
–
Time—Reset time.
The following ASIC error fault severities are supported:
• Critical—Affected component is unusable or card is reset if no redundant card exists
• Major—Partially service affecting fault or if redundant card, do a failover otherwise the card runs
in degraded mode
• Minor—Non-service affecting fault
• OK—No fault
Use the show asic-errors command to view if any ASIC errors have occurred on nodes. The following
example shows the output of the show asic-errors command.
RP/0/RP0/CPU0:router# show asic-errors plim asic 0 all location 0/0/CPU0
Wed May 2 13:45:00.626 EST EDT
************************************************************
* Single Bit Errors *
************************************************************
************************************************************
* Multiple Bit Errors *
************************************************************
************************************************************
* Parity Errors *
************************************************************
************************************************************
* CRC Errors *
************************************************************
************************************************************
* Generic Errors *
************************************************************
Name : Port 0 PAR XGM link fault
Node Key : 0x105051d
Thresh/period(s): 0/0 Alarm state: OFF
Error count : 3703662240
Last clearing : Thu Mar 29 11:59:32 2007
Last N errors : 50
--------------------------------------------------------------
First N errors.

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CRS-1 - Carrier Routing System Router and is the answer not in the manual?

Cisco CRS-1 - Carrier Routing System Router Specifications

General IconGeneral
BrandCisco
ModelCRS-1 - Carrier Routing System Router
CategoryNetwork Router
LanguageEnglish

Related product manuals