Configuration tasks (continued)
Setting the H.323 and SIP parameters
(when not set by a provisioning system)
To get online and ready to place and receive calls, your system
must be set up properly. Your system uses either the H.323
protocol or the SIP protocol for video calls.
Choose one of the following methods to set the H.323 and
SIP parameters:
Web interface Read more...
Touch controller
Read more...
Remote control
and on screen menu
Read more...
Setting date and time
(when not set by a provisioning system)
When setting up your video conference system, you should
check that the date and time settings are correct. Among other
things this information is used to time stamp messages trans-
mitted to gatekeepers and other network elements.
Choose one of the following methods to set the date and time:
Web interface Read more...
Touch controller
Read more...
Remote control
and on screen menu
Read more...
Setting the menu password
We strongly recommend that you set a password for the
Administrator Settings menu.
This menu, which is available on both the Touch controller and
the remote control, gives access to settings that affect the
behavior of the video conference system.
Choose one of the following methods to set-up the menu
password:
Remote control
and on screen menu
Read more...
Web interface Read more...
Cisco TelePresence Video Systems
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
10
Getting Started Guide
To Next Page
Loading...
Need help?
General
