Setting date, time and location
(When not set by a provisioning system)
You should check that the date and time settings are correct
when you set up your video conference system. The system
uses this information for example to time stamp messages
transmitted to gatekeepers and other network elements.
You can find the time in the top right corner of the Touch
controller display.
1.
Tap the user name in the upper left corner and tap Settings
> Date, Time & Location.
2. Tap 24h or 12h to select the Time Format you prefer.
3.
Tap dd.mm.yy, mm.dd.yy or yy.mm.dd to select the Date
Format you prefer.
4.
Select the OlsonZone for your system. Step through the list
of available zones by tapping the - or + signs.
5.
Set Date & Time Mode to Auto if you want time and date to
be regularly updated; otherwise, select Manual.
a.
If you select Manual, enter the correct value for Hour,
Minute, Year, Month, and Day. Tap the - and + signs to
increase or decrease a value.
b.
If you select Auto, the NTP server address can be
automatically obtained from the network (set the NTP
Mode to Auto) or you can enter the NTP Server address
yourself (set NTP Mode to Manual).
6.
Tap Save to confirm the changes, or Undo to leave without
saving.
7. Tap Exit to return to the home menu.
Back to task overview
Cisco TelePresence Video Systems
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
16
Getting Started Guide
To Next Page
Loading...
Need help?
General
