Setting date, time and location
(When not set by a provisioning system)
When setting up your video conference system, you should
check that the date and time settings are correct. Among other
things this information is used to time stamp messages transmit-
ted to gatekeepers and other network elements.
The time and date is shown in the top right corner of the main
display. It takes a few moments before the time on the screen
changes after changing the setup.
1. Go to Home > Settings > Date and time.
2.
Select 24 hours or 12 hours (am/pm) in the Time format
drop down list as you prefer.
3. Select Day.Month.Year, Month.Day.Year or Year.Month.Day
in the Date format drop down list as you prefer.
4. Select your time zone from the Time zone drop down list.
5.
Select Auto, Manual or Off in the NTP mode drop down list
as you prefer.*
a.
If you select Manual, also enter the NTP server address
in the corresponding input field.
b.
If you select Off, also select the correct value for Day,
Month, Year and Time in the corresponding drop down
lists.
6. Press Home ( ) to exit.
* NTP mode:
Auto: The time is regularly updated using an NTP server. The NTP server
address is automatically obtained from the network (DHCP).
Manual: The time is regularly updated using an NTP server. You must
manually enter the NTP server address.
Off: You must set the time manually. The time is not updated automatically.
Back to task overview
Always save the new value when you change a setting
•
Drop down list selection: Navigate to the correct value
and press the OK ( ) key to save, or press the left arrow
key to leave without saving.
•
Text entry in an input field: Enter the text, navigate to
Ok/Save to save the change, or navigate to Cancel
to leave without saving; then press the OK ( ) key to
confirm.
Cisco TelePresence Video Systems
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
21
Getting Started Guide
To Next Page
Loading...
Need help?
General
