Cisco Firepower 2100

no fxos mode appliance
write memory
reload
After you set the mode, you need to save the configuration and reload the device. Prior to reloading, you can
set the mode back to the original value without any disruption.
When you reload, the configuration is cleared. The default configuration is applied upon reload.
Caution
Example:
ciscoasa(config)# no fxos mode appliance
Mode set to platform mode
WARNING: This command will take effect after the running-config is saved and the system has
been rebooted. Command accepted.
ciscoasa(config)# write memory
Building configuration...
Cryptochecksum: c0532471 648dc7c2 4f2b4175 1f162684
23736 bytes copied in 1.520 secs (23736 bytes/sec)
[OK]
ciscoasa(config)# reload
Proceed with reload? [confirm]
Step 5 After restart, view the current mode to confirm the change.
show fxos mode
Example:
ciscoasa(config)# show fxos mode
Mode is currently set to platform
Step 6 (Optional) Set the mode back to Appliance mode.
fxos mode appliance
write memory
reload
After you set the mode, you need to save the configuration and reload the device. Prior to reloading, you can
set the mode back to the original value without any disruption.
When you reload, the configuration is cleared. The default configuration is applied upon reload.
Caution
Example:
ciscoasa(config)# fxos mode appliance
Mode set to appliance mode
WARNING: This command will take effect after the running-config is saved and the system has
been rebooted. Command accepted.
ciscoasa(config)# write memory
Building configuration...
Cryptochecksum: c0532471 648dc7c2 4f2b4175 1f162684
23736 bytes copied in 1.520 secs (23736 bytes/sec)
[OK]
Cisco Firepower 2100 Getting Started Guide
207
ASA Deployment with ASDM
Enable Platform Mode