Cisco Firepower 2100 User Manual

firepower login: admin
Password: Admin123
Successful login attempts for user 'admin' : 1
[...]
Hello admin. You must change your password.
Enter new password: ********
Confirm new password: ********
Your password was updated successfully.
[...]
firepower#
Step 3 If you connected to FXOS on the console port, connect to the threat defense CLI.
connect ftd
Example:
firepower# connect ftd
>
Step 4 The first time you log in to the threat defense, you are prompted to accept the End User License Agreement
(EULA) and, if using an SSH connection, to change the admin password. You are then presented with the
CLI setup script.
You cannot repeat the CLI setup wizard unless you clear the configuration; for example, by
reimaging. However, all of these settings can be changed later at the CLI using configur e network
commands. See Cisco Secure Firewall Threat Defense Command Reference.
Note
Defaults or previously entered values appear in brackets. To accept previously entered values, press Enter.
See the following guidelines:
• Do you want to configure IPv4? and/or Do you want to configure IPv6?—Enter y for at least one of
these types of addresses.
• Enter the IPv4 default gateway for the management interface and/or Enter the IPv6 gateway for
the management interface—Set a gateway IP address for Management 1/1 on the management network.
In the edge deployment example shown in the network deployment section, the inside interface acts as
the management gateway. In this case, you should set the gateway IP address to be the intended inside
interface IP address; you must later use the management center to set the inside IP address. The
data-interfaces setting applies only to the remote management center or device manager management.
• If your networking information has changed, you will need to reconnect—If you are connected with
SSH but you change the IP address at initial setup, you will be disconnected. Reconnect with the new
IP address and password. Console connections are not affected.
• Manage the device locally?—Enter no to use the management center. A yes answer means you will
use the device manager instead.
• Configure firewall mode?—We recommend that you set the firewall mode at initial configuration.
Changing the firewall mode after initial setup erases your running configuration.
Cisco Firepower 2100 Getting Started Guide
19
Threat Defense Deployment with the Management Center
Complete the Threat Defense Initial Configuration Using the CLI

Cisco Firepower 2100 Specifications

General

Brand	Cisco
Model	Firepower 2100
Category	Gateway
Language	English