Procedure
Step 1 The first time you add a device using a serial number, you need to complete the following prerequisites. After
the first time, you can skip to adding the devices directly in CDO.
a) In the management center, choose Devices > Device Management.
b) From the Add drop-down menu, choose Device.
c) Click Serial Number for the provisioning method.
Figure 40: Add Device by Serial Number
d) Create a CDO account.
If you already have preexisting but separate SecureX and CDO accounts, you need to link
them. See https://cisco.com/go/cdo-securex-link for more information about linking accounts.
Note
If you don't already have accounts, perform the following:
• Create a Cisco Security Cloud (formerly SecureX) account. See the CDO documentation for
information about how to create one.
• Request a CDO tenant. See the CDO documentation for information about requesting a new CDO
tenant.
e) Integrate the management center with Cisco Security Cloud (formerly SecureX). Click the link to open
the SecureX Integration page in the management center.
Click the Enable SecureX to open a separate browser tab to log you into your Cisco Security Cloud
account and confirm the displayed code. Make sure this page is not blocked by a pop-up blocker.
For detailed information, see .
CDO onboards the on-prem management center after you integrate the management center with Cisco
Security Cloud. CDO needs the management center in its inventory for low-touch provisioning to operate.
Cisco Firepower 2100 Getting Started Guide
71
Threat Defense Deployment with a Remote Management Center
Add a Device to the Management Center Using Low-Touch Provisioning
To Next Page
Loading...
Need help?
General