Cisco FirePOWER ASA 5500 series

14-38
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 14 Configuring Failover
Configuring Failover
Stateful Failover Logical Update Statistics
Link : fover Ethernet2 (up)
Stateful Obj xmit xerr rcv rerr
General 1950 0 1733 0
sys cmd 1733 0 1733 0
up time 0 0 0 0
RPC services 0 0 0 0
TCP conn 6 0 0 0
UDP conn 0 0 0 0
ARP tbl 106 0 0 0
Xlate_Timeout 0 0 0 0
VPN IKE upd 15 0 0 0
VPN IPSEC upd 90 0 0 0
VPN CTCP upd 0 0 0 0
VPN SDI upd 0 0 0 0
VPN DHCP upd 0 0 0 0
Logical Update Queue Information
Cur Max Total
Recv Q: 0 2 1733
Xmit Q: 0 2 15225
In multiple context mode, using the show failover command in a security context displays the failover
information for that context. The information is similar to the information shown when using the
command in single context mode. Instead of showing the active/standby status of the unit, it displays the
active/standby status of the context. Table 14-7 provides descriptions for the information shown.
Failover On
Last Failover at: 04:03:11 UTC Jan 4 2003
This context: Negotiation
Active time: 1222 (sec)
Interface outside (192.168.5.121): Normal
Interface inside (192.168.0.1): Normal
Peer context: Not Detected
Active time: 0 (sec)
Interface outside (192.168.5.131): Normal
Interface inside (192.168.0.11): Normal
Stateful Failover Logical Update Statistics
Status: Configured.
Stateful Obj xmit xerr rcv rerr
RPC services 0 0 0 0
TCP conn 99 0 0 0
UDP conn 0 0 0 0
ARP tbl 22 0 0 0
Xlate_Timeout 0 0 0 0
GTP PDP 0 0 0 0
GTP PDPMCB 0 0 0 0