xxxiv
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
About This Guide
Related Documentation
• Manage network security
• Install and configure firewalls/security appliances
• Configure VPNs
• Configure intrusion detection software
Related Documentation
For more information, refer to the following documentation:
• Cisco PIX Security Appliance Release Notes
• Cisco ASDM Release Notes
• Cisco PIX 515E Quick Start Guide
• Guide for Cisco PIX 6.2 and 6.3 Users Upgrading to Cisco PIX Software Version 7.0
• Migrating to ASA for VPN 3000 Series Concentrator Administrators
• Cisco Security Appliance Command Reference
• Cisco ASA 5500 Series Adaptive Security Appliance Getting Started Guide
• Cisco ASA 5500 Series Release Notes
• Cisco Security Appliance Logging Configuration and System Log Messages
• Cisco Secure Desktop Configuration Guide for Cisco ASA 5500 Series Administrators
Document Organization
This guide includes the chapters and appendixes described in Table 1.
Table 1 Document Organization
Chapter/Appendix Definition
Part 1: Getting Started and General Information
Chapter 1, “Introduction to the
Security Appliance”
Provides a high-level overview of the security appliance.
Chapter 2, “Getting Started” Describes how to access the command-line interface, configure the firewall mode, and
work with the configuration.
Chapter 3, “Enabling Multiple
Context Mode”
Describes how to use security contexts and enable multiple context mode.
Chapter 4, “Configuring Switch
Ports and VLAN Interfaces for
the Cisco ASA 5505 Adaptive
Security Appliance”
Describes how to configure switch ports and VLAN interfaces for the ASA 5505 adaptive
security appliance.
Chapter 5, “Configuring
Ethernet Settings and
Subinterfaces”
Describes how to configure Ethernet settings for physical interfaces and add subinterfaces.
Chapter 6, “Adding and
Managing Security Contexts”
Describes how to configure multiple security contexts on the security appliance.
To Next Page
Loading...
