Cisco FirePOWER ASA 5500 series

3-4
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 3 Enabling Multiple Context Mode
Security Context Overview
static (inside,shared) 10.10.10.0 10.10.10.0 netmask 255.255.255.0
• Context B:
static (inside,shared) 10.20.10.0 10.20.10.0 netmask 255.255.255.0
• Context C:
static (inside,shared) 10.30.10.0 10.30.10.0 netmask 255.255.255.0
Note For management traffic destined for an interface, the interface IP address is used for classification.
Invalid Classifier Criteria
The following configurations are not used for packet classification:
• NAT exemption—The classifier does not use a NAT exemption configuration for classification
purposes because NAT exemption does not identify a mapped interface.
• Routing table—If a context includes a static route that points to an external router as the next-hop
to a subnet, and a different context includes a static command for the same subnet, then the classifier
uses the static command to classify packets destined for that subnet and ignores the static route.