25-8
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 25 Configuring Application Layer Protocol Inspection
Configuring Application Inspection
h323 h225 [map_name] If you added an H323 inspection policy map according to
“Configuring an H.323 Inspection Policy Map for
Additional Inspection Control” section on page 25-38,
identify the map name in this command.
h323 ras [map_name] If you added an H323 inspection policy map according to
“Configuring an H.323 Inspection Policy Map for
Additional Inspection Control” section on page 25-38,
identify the map name in this command.
http [map_name] If you added an HTTP inspection policy map according to
the “Configuring an HTTP Inspection Policy Map for
Additional Inspection Control” section on page 25-44,
identify the map name in this command.
icmp —
icmp error —
ils —
im [map_name] If you added an Instant Messaging inspection policy map
according to “Configuring an Instant Messaging Inspection
Policy Map for Additional Inspection Control” section on
page 25-48, identify the map name in this command.
mgcp [map_name] If you added an MGCP inspection policy map according to
“Configuring an MGCP Inspection Policy Map for
Additional Inspection Control” section on page 25-54,
identify the map name in this command.
netbios [map_name] If you added a NetBIOS inspection policy map according to
“Configuring a NetBIOS Inspection Policy Map for
Additional Inspection Control” section on page 25-57,
identify the map name in this command.
pptp —
radius-accounting [map_name]The radius-accounting keyword is only available for a
management class map. See the “Creating a Layer 3/4 Class
Map for Management Traffic” section on page 21-5 for more
information about creating a management class map.
If you added a RADIUS accounting inspection policy map
according to “Configuring a RADIUS Inspection Policy
Map for Additional Inspection Control” section on
page 25-59, identify the map name in this command.
rsh —
rtsp —
sip [map_name] If you added a SIP inspection policy map according to
“Configuring a SIP Inspection Policy Map for Additional
Inspection Control” section on page 25-63, identify the map
name in this command.
Table 25-2 Protocol Keywords
Keywords Notes
To Next Page
Loading...
