30-18
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 30 Configuring Tunnel Groups, Group Policies, and Users
Configuring Tunnel Groups
hostname(config-tunnel-ipsec)# authorization-required
hostname(config-tunnel-ipsec)#
Step 5 Specify the attribute or attributes to use in deriving a name for an authorization query from a certificate.
This attribute specifies what part of the subject DN field to use as the username for authorization:
hostname(config-tunnel-ipsec)# authorization-dn-attributes {primary-attribute
[secondary-attribute] | use-entire-name}
For example, the following command specifies the use of the CN attribute as the username for
authorization:
hostname(config-tunnel-ipsec)# hostname(config-ipsec)# authorization-dn-attributes CN
hostname(config-tunnel-ipsec)#
The authorization-dn-attributes are C (Country), CN (Common Name), DNQ (DN qualifier), EA
(E-mail Address), GENQ (Generational qualifier), GN (Given Name), I (Initials), L (Locality),
N (Name), O (Organization), OU (Organizational Unit), SER (Serial Number), SN (Surname),
SP (State/Province), T (Title), and UID (User ID)
Step 6 Optionally, specify the name of the accounting-server group, if any, to use. If you are not using
accounting, go to Step 7. Use the aaa-server command to configure accounting servers. The maximum
length of the group tag is 16 characters.:
hostname(config-tunnel-general)# accounting-server-group groupname
hostname(config-tunnel-general)#
For example, the following command specifies the use of the accounting-server group comptroller:
hostname(config-tunnel-general)# accounting-server-group comptroller
hostname(config-tunnel-general)#
Step 7 Optionally, specify the name of the default group policy. The default value is DfltGrpPolicy:
hostname(config-tunnel-general)# default-group-policy policyname
hostname(config-tunnel-general)#
The following example sets MyDfltGrpPolicy as the name of the default group policy:
hostname(config-tunnel-general)# default-group-policy MyDfltGrpPolicy
hostname(config-tunnel-general)#
Step 8 Optionally, specify the name or IP address of the DHCP server (up to 10 servers), and the names of the
DHCP address pools (up to 6 pools). Separate the list items with spaces. The defaults are no DHCP
server and no address pool.
hostname(config-tunnel-general)# dhcp-server server1 [...server10]
hostname(config-tunnel-general)# address-pool [(interface name)] address_pool1
[...address_pool6]
hostname(config-tunnel-general)#
Note The interface name must be enclosed in parentheses.
You configure address pools with the ip local pool command in global configuration mode. See
Chapter 31, “Configuring IP Addresses for VPNs” for information about configuring address pools.
Step 9 Optionally, if your server is a RADIUS, RADIUS with NT, or LDAP server, you can enable password
management.
To Next Page
Loading...
