Cisco FirePOWER ASA 5500 series

B-19
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Appendix B Sample Configurations
Example 6: IPv6 Configuration
Figure B-5 IPv6 Dual Stack Configuration
enable password myenablepassword
passwd mypassword
hostname coyupix
asdm image flash:/asdm.bin
boot system flash:/image.bin
interface Ethernet0
nameif outside
security-level 0
ip address 10.142.10.100 255.255.255.0
ipv6 address 2001:400:3:1::100/64
ipv6 nd suppress-ra
ospf mtu-ignore auto
no shutdown
interface Ethernet1
nameif inside
security-level 100
ip address 10.140.10.100 255.255.255.0
ipv6 address 2001:400:1:1::100/64
ospf mtu-ignore auto
no shutdown
access-list allow extended permit icmp any any
ssh 10.140.10.75 255.255.255.255 inside
logging enable
logging buffered debugging
ipv6 enforce-eui64 inside
ipv6 route outside 2001:400:6:1::/64 2001:400:3:1::1
ipv6 route outside ::/0 2001:400:3:1::1
ipv6 access-list outacl permit icmp6 2001:400:2:1::/64 2001:400:1:1::/64
ipv6 access-list outacl permit tcp 2001:400:2:1::/64 2001:400:1:1::/64 eq telnet
ipv6 access-list outacl permit tcp 2001:400:2:1::/64 2001:400:1:1::/64 eq ftp
ipv6 access-list outacl permit tcp 2001:400:2:1::/64 2001:400:1:1::/64 eq www
access-group allow in interface outside
153155
IPv4
Network
IPv6
Network
IPv4/IPv6
Network
10.142.10.1
2001:400:3:1::1
10.142.10.100
2001:400:3:1::100
10.140.10.100
2001:400:1:1::100
2001:400:6:1::1