Index
IN-10
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
HTTP(S)
authentication
40-5
filtering 20-4
HTTP/HTTPS Web VPN proxy, setting 37-5
HTTP compression, WebVPN, enabling 30-66, 30-83
HTTP inspection
about
25-43
configuring 25-43
HTTP redirection for login, Easy VPN client on the ASA
5505
34-12
HTTPS for WebVPN sessions 37-3
hub-and-spoke VPN scenario 27-20
I
ICMP
testing connectivity
43-1
type numbers D-15
idle timeout
hardware client user, group policy
30-45
username attribute 30-72
ID method for ISAKMP peers, determining 27-6
IKE
benefits
27-2
creating policies 27-4
keepalive setting, tunnel group 30-3
pre-shared key, Easy VPN client on the ASA 5505 34-6
See also ISAKMP
ILS inspection
25-51
IM 25-62
inbound access lists 18-1
Individual user authentication 34-12
information reply, ICMP message D-15
information request, ICMP message D-15
inheritance
tunnel group
30-1
username attribute 30-71
inside, definition 1-1
inspection engines
See application inspection
Instant Messaging inspection
25-62
intercept DHCP, configuring 30-43
interfaces
ASA 5505
about
4-1
backup interface 4-6
enabled status 4-9
IP address 4-7
MAC addresses 4-4
maximum VLANs 4-2
non-forwarding 4-6
protected switch ports 4-9
switch port configuration 4-9
trunk ports 4-11
VLAN interface configuration 4-5
configuring for remote access 32-2
configuring IPv6 on 12-3
duplex 5-1
enabled status 5-1
enabling 5-2
failover monitoring 14-16
fiber 5-3
global addresses 17-23
IDs 5-2
IP address 7-4
MAC addresses
automatically assigning
6-11
manually assigning to interfaces 7-4
mapped name 6-8
naming, physical and subinterface 7-3
naming, VLAN 4-7
SFP 5-3
speed 5-1
subinterfaces 5-3
viewing monitored interface status 14-45
internal group policy, configuring 30-34
Internet Security Association and Key Management
Protocol
To Next Page
Loading...
