Index
IN-15
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
configuration 17-28
NAT ID 17-16
order of statements 17-13
overlapping addresses 17-33
PAT
about
17-6
configuring 17-22
implementation 17-16
policy NAT
about
17-9
port redirection 17-34
RPC not supported with 25-74
same security level 17-12
security level requirements 7-2
static identify, configuring 17-29
static NAT
about
17-7
configuring 17-25
static PAT
about
17-7
configuring 17-26
transparent firewall 15-10
types 17-5
native VLAN support 4-11
NAT-T
enabling IPSec over NAT-T
27-7
using 27-7
Netscape CMS, CA server support 39-5
Network Activity test 14-16
Network Address Translation
See NAT
Network Admission Control
Access Control Server
33-2
ACL, default 33-3
clientless authentication 33-5
configuring 30-50
enabling and disabling 33-2
exemptions 33-4
port 33-7
retransmission retries 33-8
retransmission retry timer 33-7
revalidation timer 33-9
session reinitialization timer 33-8
uses, requirements, and limitations 33-1
network extension mode 34-3
network extension mode, group policy 30-46
Network Ice firewall 30-56
networks, overlapping 17-33
Nokia VPN Client 27-28
NTLM support 13-5
NT server
configuring
13-12
support 13-5
O
object groups
nesting
16-14
removing 16-16
open ports D-14
operating systems, posture validation exemptions 33-4
OSPF
about
9-8
area authentication 9-12
area MD5 authentication 9-12
area parameters 9-12
authentication key 9-10
cost 9-10
dead interval 9-10
default route 9-16
displaying update packet pacing 9-17
enabling 9-8
hello interval 9-11
interface parameters 9-10
link-state advertisement 9-8
logging neighbor states 9-17
MD5 authentication 9-11
monitoring 9-18
To Next Page
Loading...
