EasyManuals Logo
Home>Cisco>Switch>IE 2000

Cisco IE 2000 User Manual

Cisco IE 2000
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
68
Connecting to SFP Modules
This section describes how to connect to a fiber-optic or copper SFP port. To connect to an RJ-45 Gigabit Ethernet port,
see Connecting to a Dual-Purpose Port, page 70. For instructions on how to install or remove an SFP module, see
Installing and Removing SFP Modules, page 64.
Warning: Class 1 laser product. Statement 1008
Warning: Do not connect or disconnect cables to the ports while power is applied to the switch or any device on
the network because an electrical arc can occur. This could cause an explosion in hazardous location installations.
Be sure that power is removed from the switch and cannot be accidentally be turned on, or verify that the area is
nonhazardous before proceeding. Statement 1070
Caution: Do not remove the rubber plugs from the SFP module port or the rubber caps from the fiber-optic cable until
you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables from contamination
and ambient light.
Caution: Before connecting to the SFP module, be sure that you understand the port and cabling guidelines in the
Preparing for Installation, page 27. See Cable and Connectors, page 85 for information about the LC on the SFP module.
Caution: To prevent ESD damage, follow standard board and component handling procedures.
Connecting to a Fiber Optic SFP Module
To connect a fiber-optic cable to an SFP module, follow these steps:
1. Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.
2. Insert one end of the fiber-optic cable into the SFP module port. See Figure 43 on page 69.

Table of Contents

Other manuals for Cisco IE 2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IE 2000 and is the answer not in the manual?

Cisco IE 2000 Specifications

General IconGeneral
BrandCisco
ModelIE 2000
CategorySwitch
LanguageEnglish

Related product manuals