5-6
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
Chapter 5 Configuring Cisco EnergyWise
Managing Single Entities
Manually Managing Power
• Powering the Entity, page 5-6
• Configuring Entity Attributes, page 5-7
• Powering the PoE Port, page 5-8
• Configuring PoE-Port Attributes, page 5-8
Powering the Entity
Beginning in privileged EXEC mode:
Command Purpose
Step 1
show energywise (Optional) Verify that EnergyWise is disabled.
Step 2
configure terminal Enter global configuration mode.
Step 3
energywise domain domain-name secret [0 | 7]
password [protocol udp port udp-port-number
[interface interface-id | ip ip-address]]
Enable EnergyWise on the entity, assign the entity to a domain
with the specified domain-name, and set the password for secure
communication among the entities in the domain.
• (Optional) 0—Use an unencrypted password. This is the
default.
• (Optional) 7—Use a hidden password.
If you do not enter 0 or 7, the entity uses the default value of
0.
• (Optional) port udp-port-number—Specify the UDP port
that sends and receives queries.
The range is from 1 to 65000. The default is 43440.
• (Optional) interface interface-id—Specify the port from
which the EnergyWise messages are sent.
• (Optional) ip ip-address—Specify the IP address from which
the EnergyWise messages are sent.
For the domain-name and password
• You can enter alphanumeric characters and symbols such as
#, (, %, !, or &.
• Do not use an asterisk (*) or a blank space between the
characters and symbols.
By default, no domain and password are assigned.
Step 4
end Return to privileged EXEC mode.
Step 5
show energywise
show energywise domain
Verify your entries.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
To Next Page
Loading...
Need help?
General
