10-2
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
Chapter 10 Configuring SDM Templates
Configuring the Switch SDM Template
The rows in the tables represent approximate hardware boundaries set when a template is selected. If a
section of a hardware resource is full, all processing overflow is sent to the CPU, seriously impacting
switch performance.
Configuring the Switch SDM Template
These sections contain this configuration information:
• Default SDM Template, page 10-2
• SDM Template Configuration Guidelines, page 10-2
• Setting the SDM Template, page 10-3
Default SDM Template
The default template is the default.
SDM Template Configuration Guidelines
Follow these guidelines when selecting and configuring SDM templates:
• When you select and configure SDM templates, you must reload the switch for the configuration to
take effect.
• If you try to configure IPv6 features without first selecting a dual IPv4 and IPv6 template, a warning
message is generated.
• Using the dual stack templates results in less TCAM capacity allowed for each resource, so do not
use if you plan to forward only IPv4 traffic.
IPv4 unicast routes 0 0 0
IPv6 multicast groups 0 0 0
Directly connected IPv6 addresses 0 0 0
Indirect IPv6 unicast routes 0 0 0
IPv4 policy-based routing aces 0 0 0
IPv4 MAC QoS ACEs 128 384 0
IPv4 MAC security ACEs 384 128 256
IPv6 policy-based routing aces 0 0 0
IPv4 MAC QoS ACEs 0 0 0
IPv4 MAC security ACEs 0 0 0
Table 10-1 Approximate Number of Feature Resources Allowed by Each Template (continued)
Resource Default QoS Dual
To Next Page
Loading...
