Cisco IE-3000-8TC - Page 13

Contents
xiii
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
EtherChannel Port Groups 13-3
Dual-Purpose Uplink Ports 13-4
Connecting Interfaces 13-4
Using Interface Configuration Mode 13-4
Procedures for Configuring Interfaces 13-6
Configuring a Range of Interfaces 13-6
Configuring and Using Interface Range Macros 13-8
Configuring Ethernet Interfaces 13-10
Default Ethernet Interface Configuration 13-10
Setting the Type of a Dual-Purpose Uplink Port 13-11
Configuring Interface Speed and Duplex Mode 13-13
Speed and Duplex Configuration Guidelines 13-13
Setting the Interface Speed and Duplex Parameters 13-14
Configuring IEEE 802.3x Flow Control 13-15
Configuring Auto-MDIX on an Interface 13-16
Adding a Description for an Interface 13-17
Configuring the System MTU 13-17
Monitoring and Maintaining the Interfaces 13-18
Monitoring Interface Status 13-19
Clearing and Resetting Interfaces and Counters 13-19
Shutting Down and Restarting the Interface 13-20
CHAPTER 14 Configuring Smartports Macros 14-1
Understanding Smartports Macros 14-1
Configuring Smartports Macros 14-1
Default Smartports Configuration 14-1
Smartports Configuration Guidelines 14-2
Applying Smartports Macros 14-3
Displaying Smartports Macros 14-5
CHAPTER 15 Configuring VLANs 15-1
Understanding VLANs 15-1
Supported VLANs 15-2
VLAN Port Membership Modes 15-3
Configuring Normal-Range VLANs 15-4
Token Ring VLANs 15-5
Normal-Range VLAN Configuration Guidelines 15-5
VLAN Configuration Mode Options 15-6
VLAN Configuration in config-vlan Mode 15-6