Cisco IE-3000-8TC User Manual

1-12
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-03
Chapter 1 Overview
Default Settings After Initial Switch Configuration
• Port parameters
– Interface speed and duplex mode is autonegotiate. For more information, see Chapter 13,
“Configuring Interface Characteristics.”
– Auto-MDIX is enabled. For more information, see Chapter 13, “Configuring Interface
Characteristics.”
– Flow control is off. For more information, see Chapter 13, “Configuring Interface
Characteristics.”
• VLANs
– Default VLAN is VLAN 1. For more information, see Chapter 15, “Configuring VLANs.”
– VLAN trunking setting is dynamic auto (DTP). For more information, see Chapter 15,
“Configuring VLANs.”
– Trunk encapsulation is negotiate. For more information, see Chapter 15, “Configuring VLANs.”
– VTP mode is server. For more information, see Chapter 16, “Configuring VTP.”
– VTP version is Version 1. For more information, see Chapter 16, “Configuring VTP.”
– Voice VLAN is disabled. For more information, see Chapter 17, “Configuring Voice VLAN.”
• STP, PVST+ is enabled on VLAN 1. For more information, see Chapter 18, “Configuring STP.”
• MSTP is disabled. For more information, see Chapter 19, “Configuring MSTP.”
• Optional spanning-tree features are disabled. For more information, see Chapter 20, “Configuring
Optional Spanning-Tree Features.”
• Flex Links are not configured. For more information, see Chapter 22, “Configuring Flex Links and
the MAC Address-Table Move Update Feature.”
• DHCP snooping is disabled. The DHCP snooping information option is enabled. For more
information, see
Chapter 23, “Configuring DHCP Features and IP Source Guard.”
• DHCP server port-based address allocation is disabled. For more information, see Chapter 23,
“Configuring DHCP Features and IP Source Guard.”
• IGMP snooping is enabled. No IGMP filters are applied. For more information, see Chapter 25,
“Configuring IGMP Snooping and MVR.”
• IGMP throttling setting is deny. For more information, see Chapter 25, “Configuring IGMP
Snooping and MVR.”
• The IGMP snooping querier feature is disabled. For more information, see Chapter 25, “Configuring
IGMP Snooping and MVR.”
• MVR is disabled. For more information, see Chapter 25, “Configuring IGMP Snooping and MVR.”
• Port-based traffic
– Broadcast, multicast, and unicast storm control is disabled. For more information, see
Chapter 26, “Configuring Port-Based Traffic Control.”
– No protected ports are defined. For more information, see Chapter 26, “Configuring Port-Based
Traffic Control.”
– Unicast and multicast traffic flooding is not blocked. For more information, see Chapter 26,
“Configuring Port-Based Traffic Control.”
– No secure ports are configured. For more information, see Chapter 26, “Configuring Port-Based
Traffic Control.”
• CDP is enabled. For more information, see Chapter 28, “Configuring CDP.”

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes