CHAPTER 2
Switch Installation
This chapter contains the following sections:
• Warnings, on page 15
• Installation Guidelines, on page 17
• Verifying Switch Operation, on page 17
• Installing the Switch, on page 17
Warnings
These warnings are translated into several languages in the Regulatory Compliance and Safety Information
for the Cisco IE 4010 Switch document.
These warning statements apply to all the switches:
Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces,
and watches). Metal objects will heat up when connected to power and ground and can cause serious burns
or weld the metal object to the terminals. Statement 43
Warning
Read the installation instructions before you connect the system to its power source. Statement 1004
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed only
through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence
of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician
if you are uncertain that suitable grounding is available. Statement 1024
Warning
Cisco IE 4010 Switch Hardware Installation Guide
15
To Next Page
Loading...
Need help?
General