EMC Environmental Conditions for Products Installed in the
European Union
This section applies to products to be installed in the European Union.
The equipment is intended to operate under the following environmental conditions with respect to EMC:
• A separate defined location under the user’s control.
• Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.
• AC-power distribution shall be one of the following types, where applicable: TN-S and TN-C as defined
in IEC 364-3.
In addition, if equipment is operated in a domestic environment, interference could occur.
Hazardous Locations Standards
Les normes suivantes ont été appliquées pour les
approbations et les certifications dans le cadre
d'environnements dangereux :
The following standards were used for the hazardous
locations approvals and certifications:
ANSI/ASA 12.12.01-2013ANSI/ASA 12.12.01-2013
CAN/CSA C22.2 n° 60079-0-11 Éd. 2CAN/CSA C22.2 No. 60079-0-11 Ed. 2
CAN/CSA C22.2 n° 60079-15-12 Éd. 1CAN/CSA C22.2 No. 60079-15-12 Ed. 1
CSA C22.2 n° 213-M1987CSA C22.2 No. 213-M1987
EN 60079-0:2012+A11:2013EN 60079-0:2012+A11:2013
EN 60079-15:2010EN 60079-15:2010
IEC 60079-0, 6e éditionIEC 60079-0 6th Edition
IEC 60079-15, 4e éditionIEC 60079-15 4th Edition
UL 60079-0, 5e éd., 21-10-2009UL 60079-0, 5th Ed, 2009-10-21
UL 60079-15, 3e éd., 17-07-2009UL 60079-15, 3rd Ed, 2009-7-17
Les marques d'homologation relatives aux
environnements dangereux suivantes sont apposées
sur le point d'accès :
The following hazardous locations strings are
provided on the access point:
Classe 1, Div 2, Groupes A B C DClass 1, Div 2, Groups A B C D
Classe 1, Zone 2, Ex nA nC IIC T4 Gc XClass 1, Zone 2, Ex nA nC IIC T4 Gc X
II 3 G, Ex nA nC IIC T4 GcII 3 G, Ex nA nC IIC T4 Gc
Cisco IE 4010 Switch Hardware Installation Guide
58
Hazardous Location Installation Information
EMC Environmental Conditions for Products Installed in the European Union
To Next Page
Loading...
Need help?
General