Step 11 Enter all entries in English letters and Arabic numbers.
In the Network Settings (Required for Static IP):
• IP Address: Enter a valid IP address for the switch.
You can later use the IP address to access the switch through Device Manager.
• Switch Username and Password : Enter a password. The password can be from 1 to 25 alphanumeric characters,
can start with a number, is case sensitive, allows embedded spaces, but does not allow spaces at the beginning or
end. In the Confirm Password field, enter the password again.
You must change the password from the default password, cisco.
Note
• Default Gateway: Enter the IP address of the router.
Cisco IE 4010 Switch Hardware Installation Guide
67
Configuring the Switch with the CLI Setup Program
Express Setup Procedure
To Next Page
Loading...
