Cisco IE 4010 User Manual

Redundancy statusREDUN
Synchronous Ethernet statusSYNCE
PoE statusPoE
Display Mode buttonDISPLAY MODE
For more information about these LEDs, see Switch Panel LEDs, on page 6.
Power Supply Features
The switch has two slots for power-supply modules:
• PWR-RGD-LOW-DC-H: low-voltage DC
• PWR-RGD-AC-DC-H: high-voltage AC or DC
Note: For detailed specifications, see the IE 4010 Data Sheet.
Only the -H version power supplies are certified safe for hazardous environments.
Caution
The switch supports these power-supply module combinations:
• Single low-voltage DC
• Single high-voltage AC or DC
• Two high-voltage AC or DC
• Two low-voltage DC
• One high-voltage AC or DC and one low-voltage DC
For information on installing the power-supply modules, see Power Supply Installation, on page 37.
See Power-Supply Module LEDs, on page 10 for information on the power supply LEDs.
Management Options
Cisco IOS CLI
• You can configure and monitor the switch from the CLI. Connect your management station to the switch
console port or use Telnet from a remote management station. See the switch command reference on
Cisco.com for information.
SNMP network management
• You can manage switches from a Simple Network Management Protocol (SNMP)-compatible management
station. The switch supports a comprehensive set of Management Information Base (MIB) extensions
and four Remote Monitoring (RMON) groups. See the switch software configuration guide on Cisco.com
and the documentation that came with your SNMP application for information.
Cisco IE 4010 Switch Hardware Installation Guide
13
Product Overview
Power Supply Features

Cisco IE 4010 Specifications

General

Brand	Cisco
Model	IE 4010
Category	Switch
Language	English