Cisco IE 4010

CHAPTER 3
Power Supply Installation
This chapter describes how to remove and install a new or replacement power supply. Your switch ships with
at least one installed power-supply module (AC or DC, depending on your order).
The power-supply modules are field-replaceable units (FRUs) and are hot-swappable when deployed in
non-hazardous locations.
For translations of the safety warnings in this chapter, see the Regulatory Compliance and Safety Information
for the Cisco IE 4010 Switch on Cisco.com.
• Power-Supply Modules, on page 37
• Power-Supply Module Installation, on page 39
Power-Supply Modules
DescriptionModel
Low-voltage DC. For detailed specifications, see the
IE 4010 Data Sheet.
PWR-RGD-LOW-DC-H
High-voltage AC or DC. For detailed specifications,
see the Cisco Industrial Ethernet 4010 Series Switches
Data Sheet.
PWR-RGD-AC-DC-H
Cisco IE 4010 Switch Hardware Installation Guide
37