• File Name: Cisco_usbconsole_driver_3_1.zip
• Size: 14.35 MB (15045453 bytes)
• MD5 Checksum: eff2e955edcdc70209e6f9c8f6bd59cd
2. Unzip the file and install the corresponding exe file.
3. Navigate to the Device Manager window by performing a search in WIndows for Device Manager and
opening it.
4. Connect the USB cable from the Windows PC to the Cisco switch.
5. From the Device Manager page, expand Ports (COM & LPT). Select USB Serial Port. Right-click and
select Update Driver Software
6. In the Update Driver Software window, select Browse my computer for driver software. Then choose Let
me pick from a list of device drivers on my computer and click Next.
7. Enable Show compatible hardware and choose Cisco Serial as the model. Click Next.
After the update is completed, Windows displays Windows has successfully updated your driver software.
8. Click Close.
Uninstalling the Cisco Microsoft Windows XP, 2000, Vista, 7, 8, and 10 USB
Driver
Note: Disconnect the switch console terminal before uninstalling the driver.
1. Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit.
2. Click Next.
3. When the InstallShield Wizard for Cisco Virtual Com appears, click Next.
4. When the Program Maintenance window appears, select the Remove radio button.
5. Click Next.
6. When the Remove the Program window appears, click Remove.
If a User Account Control warning appears, click Allow - I trust this program to proceed.
7. When the InstallShield Wizard Completed window appears, click Finish.
Entering the Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch
powers on. You must assign an IP address and other configuration information necessary for the switch to
communicate with the local routers and the Internet.
Cisco IE 4010 Switch Hardware Installation Guide
73
Configuring the Switch with the CLI Setup Program
Uninstalling the Cisco Microsoft Windows XP, 2000, Vista, 7, 8, and 10 USB Driver
To Next Page
Loading...
Need help?
General