Cisco IE 4010 User Manual

This unit might have more than one power supply connection. All connections must be removed to de-energize
the unit. Statement 1028
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
For connections outside the building where the equipment is installed, the following ports must be connected
through an approved network termination unit with integral circuit protection. 10/100/1000 Ethernet Statement
1044
Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended
ambient temperature of :
140°F (60°C) Statement 1047
Warning
Operating temperatures exceeding 60C are not covered by the product safety certifications and approvals.
However, the switch can function in the installations under the environmental conditions listed Switch
Specifications.
Note
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
For U.S. installations, refer to national electrical code ANSI/NFPA 70.
Note
To prevent airflow restriction, allow clearance around the ventilation openings to be at least: 1.75 in. (4.4
cm). Statement 1076
Warning
Avoid using or servicing any equipment that has outdoor connections during an electrical storm. There may
be a risk of electric shock from lightning. Statement 1088
Warning
Cisco IE 4010 Switch Hardware Installation Guide
16
Switch Installation
Warnings

Cisco IE 4010 Specifications

General

Brand	Cisco
Model	IE 4010
Category	Switch
Language	English