CHAPTER 14
iWAG Scalability and Performance
The infrastructure of a service provider must be capable of supporting the services that an enterprise customer
or Internet service provider (ISP) wants to offer its subscribers. The service provider must also be able to
scale up to an expanding subscriber base. You can configure IWAG on the Cisco ASR1000 Series Routers
for high scalability and performance.
•
iWAG Scaling, page 131
•
Restrictions for iWAG Scalability, page 132
•
Layer 4 Redirect Scaling, page 133
•
Configuring Call Admission Control, page 133
•
Walk-by User Support for PWLAN in iWAG, page 133
•
Additional References, page 134
•
Feature Information for iWAG Scalability and Performance, page 135
iWAG Scaling
The ASR 1000 Series Routers can be deployed as an IP session aggregator. The maximum number of IP
sessions that can be supported depends on the hardware combination.
Table below lists the iWAG scaling numbers and maximum number of IP sessions supported on the ASR
1000 hardware:
•
Hardware combination and the maximum number of IP sessions that are supported when used for SP
WiFi applications.
The session limits apply to all variety of IP session initiators: DHCP, unclassified Mac address, unclassified
IP, and radius proxy.
•
Hardware combinations for SP WiFi applications and the corresponding Simple IP use case scale numbers
for authenticated and walk-by users.
Intelligent Wireless Access Gateway Configuration Guide
OL-30226-03 131
To Next Page
Loading...
Need help?
General
