Cisco Intelligent Wireless Access Gateway User Manual

CHAPTER 2
IP Sessions Over Gigabit EtherChannel
The IP Sessions over Gigabit EtherChannel (IPoGEC) feature enables you to add the Link Aggregation
Control Protocol (LACP) functionality for IP sessions. The LACP defines a virtual interface for a port channel
or a port bundle, and adds physical member links to the port channel. This section provides information
about the IPoGEC and how to configure it.
•
Finding Feature Information, page 25
•
Restrictions for IPoGEC, page 25
•
Information About IP Sessions over Gigabit EtherChannel, page 26
•
Configuring IP Sessions over Gigabit EtherChannel, page 26
•
Configuring Member Links for IP Sessions over Gigabit EtherChannel, page 28
•
Configuration Examples for IP Sessions Over Gigabit EtherChannel, page 29
•
Additional References, page 29
•
Feature Information for IP Sessions over Gigabit EtherChannel, page 30
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.
Restrictions for IPoGEC
IP Sessions over Gigabit EtherChannel (IPoGEC) currently supports the 1:1 model, where only one member
link is active while the second member link is passive and does not carry traffic.
Intelligent Wireless Access Gateway Configuration Guide
OL-30226-03 25

Cisco Intelligent Wireless Access Gateway Specifications

General

Brand	Cisco
Model	Intelligent Wireless Access Gateway
Category	Gateway
Language	English