Cisco MX700 - Xcommand Usermanagement User Passphrase Change; Xcommand Usermanagement User Passphrase Set; Video Commands; Xcommand Video Activespeakerpip Set

D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
Copyright © 2017 Cisco Systems, Inc. All rights reserved. 165
Cisco TelePresence MX700 and MX800
API Reference Guide
xCommand UserManagement User Passphrase Change
Change the passphrase for the user you logged in as. If you are logged in as the administrator,
this will change the administrator passphrase.
Requires user role: ADMIN, AUDIT, INTEGRATOR, ROOMCONTROL, USER
USAGE:
xCommand UserManagement User Passphrase Change NewPassphrase: "NewPassphrase"
OldPassphrase: "OldPassphrase"
where
NewPassphrase: String (0, 255)
OldPassphrase: String (0, 255)
xCommand UserManagement User Passphrase Set
Set a user passphrase for the specified user. You must be logged in as an administrator to set a
user passphrase.
Requires user role: ADMIN
USAGE:
xCommand UserManagement User Passphrase Set NewPassphrase: "NewPassphrase"
Userna me: "Username" YourPassphrase: "YourPassphrase"
where
NewPassphrase: String (0, 255)
Username: String (0, 127)
YourPassphrase: String (0, 255)
Video commands
xCommand Video ActiveSpeakerPIP Set
Sets position for the active speakers PiP (picture in picture).
Requires user role: ADMIN, USER
USAGE:
xCommand Video ActiveSpeakerPIP Set Position: Position
where
Position: CenterLeft/CenterRight/LowerLeft/LowerRight/UpperCenter/UpperLeft/UpperRight
Select one of the predefined positions.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xCommand