Cisco MX700 - Xconfiguration Network [1] IEEE8021 X Mode; Xconfiguration Network [1] IEEE8021 X Tlsverify; Xconfiguration Network [1] IEEE8021 X Useclientcertificate; Xconfiguration Network [1] IEEE8021 X Identity

D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
Copyright © 2017 Cisco Systems, Inc. All rights reserved. 65
Cisco TelePresence MX700 and MX800
API Reference Guide
xConfiguration Network [1] IEEE8021X Mode
The system can be connected to an IEEE 802.1X LAN network, with a port-based network
access control that is used to provide authenticated network access for Ethernet networks.
Requires user role: ADMIN, USER
Default value: Off
USAGE:
xConfiguration Network n IEEE8021X Mode: Mode
where
n : Index that identifies the network. Range: 1..1
Mode : Off/On
Off: The 802.1X authentication is disabled (default).
On: The 802.1X authentication is enabled.
xConfiguration Network [1] IEEE8021X TlsVerify
Verification of the server-side certificate of an IEEE802.1x connection against the certificates in
the local CA-list when TLS is used. The CA-list must be uploaded to the video system. This can
be done from the web interface.
This setting takes effect only when Network [1] IEEE8021X Eap Tls is enabled (On).
Requires user role: ADMIN, USER
Default value: Off
USAGE:
xConfiguration Network n IEEE8021X TlsVerify: TlsVerify
where
n : Index that identifies the network. Range: 1..1
TlsVerify : Off/On
Off: When set to Off, TLS connections are allowed without verifying the server-side
X.509 certificate against the local CA-list. This should typically be selected if no CA-list
has been uploaded to the codec.
On: When set to On, the server-side X.509 certificate will be validated against the local
CA-list for all TLS connections. Only servers with a valid certificate will be allowed.
xConfiguration Network [1] IEEE8021X UseClientCertificate
Authentication using a private key/certificate pair during an IEEE802.1x connection. The authen-
tication X.509 certificate must be uploaded to the video system. This can be done from the
web interface.
Requires user role: ADMIN, USER
Default value: Off
USAGE:
xConfiguration Network n IEEE8021X UseClientCertificate: UseClientCertificate
where
n : Index that identifies the network. Range: 1..1
UseClientCertificate : Off/On
Off: When set to Off client-side authentication is not used (only server-side).
On: When set to On the client (video system) will perform a mutual authentication TLS
handshake with the server.
xConfiguration Network [1] IEEE8021X Identity
Define the user name for 802.1X authentication.
Requires user role: ADMIN, USER
Default value: ""
USAGE:
xConfiguration Network n IEEE8021X Identity: "Identity"
where
n : Index that identifies the network. Range: 1..1
Iden tity : String (0, 64)
The user name for 802.1X authentication.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xConfiguration