Cisco MX700 - Audio Status; Xstatus Audio Input Connectors HDMI [N] Ecreferencedelay; Xstatus Audio Input Connectors Microphone [N] Ecreferencedelay; Xstatus Audio Input Localinput [N] AGC

D15335.08 Cisco TelePresence MX700 and MX800 API Reference Guide CE9.2, NOVEMBER 2017.
Copyright © 2017 Cisco Systems, Inc. All rights reserved. 178
Cisco TelePresence MX700 and MX800
API Reference Guide
Audio status
xStatus Audio Input Connectors HDMI [n] EcReferenceDelay
Returns the detected latency for each loudspeaker to microphone path for systems supporting
HDMI input used as microphone input. The result is in milliseconds.
Requires user role: ADMIN, USER
Value space of the result returned:
Integer
Example:
xStatus Audio Input Connectors HDMI 1 EcReferenceDelay
*s Audio Connectors HDMI 1 EcReferenceDelay: 0
** end
xStatus Audio Input Connectors Microphone [n] EcReferenceDelay
Returns the detected latency for each loudspeaker to microphone path. The result is in
milliseconds.
Requires user role: ADMIN, USER
Value space of the result returned:
Integer
Example:
xStatus Audio Input Connectors Microphone 1 EcReferenceDelay
*s Audio Connectors Microphone 1 EcReferenceDelay: 120
** end
xStatus Audio Input LocalInput [n] AGC
Shows the AGC (Automatic Gain Control) mode on the local input.
You can run the command xStatus Audio Input LocalInput to find the identity [n] of the input.
Requires user role: ADMIN, USER
Value space of the result returned:
On/Off
Example:
xStatus Audio Input LocalInput 1 AGC
*s Audio Input LocalInput 1 AGC: "On"
** end
xStatus Audio Input LocalInput [n] Channels
States if the local input channels are mixed into into a mono signal (1) or stereo signal (2).
You can run the command xStatus Audio Input LocalInput to find the identity [n] of the input.
Requires user role: ADMIN, USER
Value space of the result returned:
1..2
Example:
xStatus Audio Input LocalInput 1 Channels
*s Audio Input LocalInput 1 Channels: 1
** end
xStatus Audio Input LocalInput [n] Connector
Lists the connectors that are attached to the local input.
You can run the command xStatus Audio Input LocalInput to find the identity [n] of the input.
Requires user role: ADMIN, USER
Example:
xStatus Audio Input LocalInput 1 Connector
*s Audio Input LocalInput 1 Connector: "Microphone.1"
** end
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xSt atus