Cisco Nexus 3548 - Configuring Link Notifications

PurposeCommand
Enables all SNMP notifications.switch(config)# snmp-server enable traps
Enables the AAA SNMP notifications.switch(config)# snmp-server enable traps aaa
[server-state-change]
Enables the ENTITY-MIB SNMP notifications.switch(config)# snmp-server enable traps entity
[fru]
Enables the license SNMP notification.switch(config)# snmp-server enable traps license
Enables the port security SNMP notifications.switch(config)# snmp-server enable traps
port-security
Enables the SNMP agent notifications.switch(config)# snmp-server enable traps snmp
[authentication]
Configuring Link Notifications
You can configure which linkUp/linkDown notifications to enable on a device. You can enable the following
types of linkUp/linkDown notifications:
• cieLinkDown—Enables the Cisco extended link state down notification.
• cieLinkUp—Enables the Cisco extended link state up notification.
• cisco-xcvr-mon-status-chg—Enables the Cisco interface transceiver monitor status change notification.
• delayed-link-state-change—Enables the delayed link state change.
• extended-linkUp—Enables the Internet Engineering Task Force (IETF) extended link state up notification.
• extended-linkDown—Enables the IETF extended link state down notification.
• linkDown—Enables the IETF Link state down notification.
• linkUp—Enables the IETF Link state up notification.
Procedure
PurposeCommand or Action
Enters global configuration
mode.
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 1
Enables the link SNMP
notifications.
snmp-server enable traps link [cieLinkDown | cieLinkUp |
cisco-xcvr-mon-status-chg | delayed-link-state-change] |
extended-linkUp | extended-linkDown | linkDown | linkUp]
Step 2
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 6.x
130
Configuring SNMP
Configuring Link Notifications