Cisco Nexus 3548 - Disabling DOM Logging; Verifying the DOM Logging Configuration; Verifying the System Message Logging Configuration

The following example shows how to enable DOM logging.
switch# configure terminal
switch(config)# system ethernet dom polling
Disabling DOM Logging
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Disables transceiver digital optical monitoring
periodic polling.
switch(config)# no system ethernet dom
polling
Step 2
The following example shows how to disable DOM logging.
switch# configure terminal
switch(config)# no system ethernet dom polling
Verifying the DOM Logging Configuration
PurposeCommand
Displays the transceiver digital optical monitoring
periodic polling status.
show system ethernet dom polling status
Verifying the System Message Logging Configuration
Use these commands to verify system message logging configuration information:
PurposeCommand
Displays the console logging configuration.show logging console
Displays the logging configuration.show logging info
Displays the IP access list cache.show logging ip access-list cache
Displays detailed information about the IP access list
cache.
show logging ip access-list cache detail
Displays the status of the IP access list cache.show logging ip access-list status
Displays the last number of lines of the log file.
show logging last number-lines
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 6.x
80
Configuring System Message Logging
Disabling DOM Logging