[########################################] 100%
switch(config)#
Configuring the NTP Source IP Address
NTP sets the source IP address for all NTP packets based on the address of the interface through which the
NTP packets are sent. You can configure NTP to use a specific source IP address.
To configure the NTP source IP address, use the following command in global configuration mode:
Procedure
PurposeCommand or Action
Configures the source IP address for all NTP packets.
The ip-address can be in IPv4 or IPv6 format.
switch(config)# [no] ntp source
ip-address
Step 1
This example shows how to configure NTP to a source IP address:
switch(config)# ntp source 192.0.2.1
Configuring the NTP Source Interface
You can configure NTP to use a specific interface.
To configure the NTP source interface, use the following command in global configuration mode:
Procedure
PurposeCommand or Action
Configures the source interface for all NTP packets.
Use the ? keyword to display a list of supported
interfaces.
switch(config)# [no] ntp
source-interface interface
Step 1
This example shows how to configure NTP to a specific interface:
switch(config)# ntp source-interface
ethernet 2/1
Configuring NTP Logging
You can configure NTP logging in order to generate system logs with significant NTP events. NTP logging
is disabled by default.
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 6.x
60
Configuring NTP
Configuring the NTP Source IP Address
To Next Page
Loading...
