Cisco Nexus 3548 - Committing the Active Package Set

PurposeCommand or Action
Activates a package that was added to the device. SMU
packages remain inactive until activated. (Skip this
install activate filename [test]
Example:
switch# install activate
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
Step 3
step if the package was activated earlier with the install
add activate command.)
Press ? after a partial package name to display
all possible matches available for activation.
If there is only one match, press the Tab key
to fill in the rest of the package name.
Note
Example:
switch# install activate
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
Install operation 1 completed
successfully at
Thu Jan 9 01:27:56 2014
Example:
switch# install activate
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
Install operation 2 !!WARNING!! This
patch will get
activated only after a reload of the
switch. at
Sun Mar 9 00:42:12 2014
Activates additional packages as required.Repeat Step 3 until all packages are
activated.
Step 4
(Optional)
Displays all active packages. Use this command to
determine if the correct packages are active.
show install active
Example:
switch# show install active
Step 5
Committing the Active Package Set
When an SMU package is activated on the device, it becomes part of the current running configuration. To
make the package activation persistent across system-wide reloads, you must commit the package on the
device.
Procedure
PurposeCommand or Action
Commits the current set of packages so that
these packages are used if the device is
restarted.
install commit filename
Example:
switch# install commit
n3500-uk9.6.0.2.U6.0.1.CSCab00001.bin
Step 1
(Optional)
Displays which packages are committed.
show install committed
Example:
switch# show install committed
Step 2
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 6.x
184
Performing Software Maintenance Upgrades (SMUs)
Committing the Active Package Set