Cisco Nexus 3548 - Feature History for Warp SPAN

Procedure
PurposeCommand or Action
Displays information about a specific SPAN
session, all SPAN sessions, or a range of SPAN
sessions.
switch(config)# show monitor session
{number | all | range}
Step 1
Displays information about only the Warp SPAN
sessions.
switch(config)# show monitor session
warp
Step 2
This example shows how to display information about all SPAN sessions and only the Warp SPAN sessions:
switch(config)# show monitor session all
session warp
---------------
type : local
state : up
source intf :
rx : Eth1/36
tx :
both :
source VLANs :
rx :
destination ports : Eth1/1 Eth1/2 Eth1/3 Eth1/4
Legend: f = forwarding enabled, l = learning enabled
switch(config)# show monitor session warp
session warp
---------------
type : local
state : up
source intf :
rx : Eth1/36
tx :
both :
source VLANs :
rx :
destination ports : Eth1/1 Eth1/2 Eth1/3 Eth1/4
Legend: f = forwarding enabled, l = learning enabled
Feature History for Warp SPAN
Feature InformationReleaseFeature Name
This feature was introduced.5.0(3)A1(2)Warp SPAN
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 6.x
158
Configuring Warp SPAN
Feature History for Warp SPAN