Cisco Nexus 3548 - Configuration Example for Session Manager; Verifying the Session Manager Configuration

PurposeCommand
Discards the configuration session without applying
the commands.
switch(config-s)# abort
Configuration Example for Session Manager
The following example shows how to create a configuration session for ACLs:
switch# configure session name test2
switch(config-s)# ip access-list acl2
switch(config-s-acl)# permit tcp any any
switch(config-s-acl)# exit
switch(config-s)# interface Ethernet 1/4
switch(config-s-ip)# ip port access-group acl2 in
switch(config-s-ip)# exit
switch(config-s)# verify
switch(config-s)# exit
switch# show configuration session test2
Verifying the Session Manager Configuration
To verify Session Manager configuration information, perform one of the following tasks:
PurposeCommand
Displays the contents of the configuration session.
show configuration session [name]
Displays the status of the configuration session.
show configuration session status [name]
Displays a summary of all the configuration sessions.show configuration session summary
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 6.x
34
Configuring Session Manager
Configuration Example for Session Manager