Cisco Nexus 3548 - Commiting NTP Configuration Changes; Discarding NTP Configuration Changes

This example shows how to enable CFS distribution for NTP:
switch# config t
Enter configuration commands, one per
line. End with CNTL/Z.
switch(config)# ntp distribute
switch(config)# copy running-config
startup-config
Commiting NTP Configuration Changes
When you commit the NTP configuration changes, the effective database is overwritten by the configuration
changes in the pending database and all the devices in the network receive the same configuration.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Distributes the NTP configuration changes to all Cisco
NX-OS devices in the network and releases the CFS lock.
switch(config)# ntp commit
Step 2
This command overwrites the effective database with the
changes made to the pending database.
This example shows how to commit the NTP configuration changes:
switch(config)# ntp commit
Discarding NTP Configuration Changes
After making the configuration changes, you can choose to discard the changes instead of committing them.
If you discard the changes, Cisco NX-OS removes the pending database changes and releases the CFS lock.
To discard NTP configuration changes, use the following command in global configuration mode:
Procedure
PurposeCommand or Action
Discards the NTP configuration changes in the pending database
and releases the CFS lock. Use this command on the device
where you started the NTP configuration.
switch(config)# ntp abort
Step 1
This example shows how to discard the NTP configuration changes:
switch(config)# ntp abort
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 6.x
62
Configuring NTP
Commiting NTP Configuration Changes