Cisco Nexus 3548 - Page 186

PurposeCommand or Action
Resumes (enables) the specified ERSPAN sessions.
The session range is from . By default, sessions are
created in the shut state. .
If a monitor session is enabled but its
operational status is down, then to enable
the session, you must first specify the
monitor session shut command followed
by the no monitor session shut command.
Note
no monitor session {session-range | all}
shut
Example:
switch(config)# no monitor session 3
shut
Step 3
Enters the monitor configuration mode for the
ERSPAN source type. The new session
monitor session session-number type
erspan-source
Step 4
configuration is added to the existing session
configuration.
Example:
switch(config)# monitor session 3
type erspan-source
switch(config-erspan-src)#
Enters the monitor configuration mode for the
ERSPAN destination type.
monitor session session-number type
erspan-destination
Example:
switch(config-erspan-src)# monitor
session 3 type erspan-destination
Step 5
Shuts down the ERSPAN session. By default, the
session is created in the shut state.
shut
Example:
switch(config-erspan-src)# shut
Step 6
Enables the ERSPAN session. By default, the
session is created in the shut state.
no shut
Example:
switch(config-erspan-src)# no shut
Step 7
(Optional)
Displays the status of ERSPAN sessions.
show monitor session all
Example:
switch(config-erspan-src)# show
monitor session all
Step 8
(Optional)
Displays the running ERSPAN configuration.
show running-config monitor
Example:
switch(config-erspan-src)# show
running-config monitor
Step 9
(Optional)
Displays the ERSPAN startup configuration.
show startup-config monitor
Example:
switch(config-erspan-src)# show
startup-config monitor
Step 10
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 6.x
170
Configuring ERSPAN
Shutting Down or Activating an ERSPAN Session