Cisco Nexus 5500 Series - Page 116

1110
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter M Commands
monitor erspan origin ip-address
monitor erspan origin ip-address
To configure the Encapsulated Remote Switched Port Analyzer (ERSPAN) origin IP address, use the
monitor espan origin ip-address command. To remove the ERSPAN origin IP address configuration,
use the no form of this command.
monitor erspan origin ip-address ip-address [global]
no monitor erspan origin ip-address ip-address [global]
Syntax Description
Command Default None
Command Modes Global configuration mode
Command History
Usage Guidelines When you change the origin IP address in the default VDC, it impacts all the sessions.
This command does not require a license.
Examples This example shows how to configure the ERSPAN origin IP address:
switch# configure terminal
switch(config)# monitor erspan origin ip-address 10.1.1.1 global
switch(config)#
This example shows how to remove the ERSPAN IP address:
switch# configure terminal
switch(config)# no monitor erspan origin ip-address 10.1.1.1 global
switch(config)#
Related Commands
ip-address IP address.
global (Optional) Specifies the default virtual device context (VDC) configuration
across all VDCs.
Release Modification
5.2(1)N1(1) This command was introduced.
Command Description
monitor session Configures a SPAN or an ERSPAN session.